Modules & Options
7 - 20 3.75G/HSPA Module
7
3G Watcher Application
With the 3.75G/HSPA and USIM card (provided by your service provider) installed
you may then install the 3G Watcher application. The 3G Watcher application al-
lows you to directly access your 3.75G internet service from the computer.
3G Watcher Application Installation
1. Enable power to the module by pressing the Fn + key combination (give
the module about 10 seconds to power on - the on screen icon will
indicate the module’s power status).
2. If a Found New Hardware window appears, click Cancel in all windows
that appear, and then proceed to install the driver as below.
3. Insert the Device Drivers & Utilities + User’s Manual disc into the CD/
DVD drive.
4. Click Option Drivers (button).
5. Click
2.Install 3G Driver
> Yes
.
6. Click Next.
7. Click the button to accept the license agreement, and then click Install.
8. When the next screen appears wait (about 2 minutes) until the 3G
Watcher application appears on screen (as per Figure 7 - 12) before
clicking Finish (this allows the hardware to detect the 3.75G module).
Wireless Device
Operation Aboard
Aircraft
The use of any portable
electronic transmission de-
vices aboard aircraft is usu-
ally prohibited. Make sure
the module(s) are OFF if
you are using the computer
aboard aircraft.
Use the Fn + key com-
bination to toggle power to
the 3.75G/HSPA module,
and check the indicator to
see if the module is pow-
ered on or not (see Table 1
- 5, on page 1 - 15/ Table 1
- 3, on page 1 - 11).
Figure 7 - 12
3G Watcher
Application
To Next Page
Loading...
