Modules & Options
3.75G/HSPA Module 7 - 19
7
Before installing the application, make sure that the 3.75G/HSPA module is ON
(installing the driver with the module off will not allow the software to detect the
module hardware correctly). Use the Fn + key combination (see Table 1 - 5, on
page 1 - 15) to toggle power to the 3.75G/HSPA module.
When the
3.75G/HSPA
module is powered on, the indicator will briefly be displayed. Make sure you in-
stall the drivers in the order indicated in
Table 4 - 1, on page 4 - 3
.
Note that exiting
the application does NOT turn off the 3.75G/HSPA module.
• 3G Watcher - See “3G Watcher Application” on page 7 - 20 for driver installa-
tion information and “Setting Up a Carrier Profile” on page 7 - 21 for instruc-
tions on using the 3G Watcher application.
• HSPA Modem Interface - See “HSPA Modem Interface Installation” on
page 7 - 27 for driver installation information and “HSPA Modem Interface”
on page 7 - 28 for instructions on using the HSPA Modem Interface.
• Mobile Partner - See “Mobile Partner Application Installation” on page 7 -
36 for driver installation information and “Mobile Partner Application” on
page 7 - 37 for instructions on using the Mobile Partner application.
3.75G/HSPA
Modules & System
Wake Up
Note that the 3.75G mod-
ules
DO NOT
support
system wake up on
3.75G/HSPA modem ac-
tivity.
To Next Page
Loading...
