Modules & Options
7 - 18 3.75G/HSPA Module
7
5. Insert the USIM card as you would into your mobile phone.
6. Slide the SIMLOCK towards the hinge (in the opposite direction to the arrow
illustrated in Figure 7 - 11) in order to release the lock and lift it up.
7. Insert the USIM card as illustrated in (Figure 7 - 10) and close the SIMLOCK.
8. Lock the SIMLOCK by pushing it in the direction of the arrow in Figure 7 - 11 until
it clicks into the lock position.
9. Replace the covers and screws (r
econnect the fan cable before screwing down
the bay cover for Model E & F computers - see sidebar for note on cover pins
).
Figure 7 - 10
Insert the USIM
Card
Figure 7 - 11
SIMLOCK Lock
Cover Pins
Note that Models E & F
have cover pins that need
to be aligned with slots in
the case to insure a prop-
er cover fit, before screw-
ing down the bay cover.
Models A - D
Models E & FModels A - D
To Next Page
Loading...
