Windows 7 Information
3.75G/HSPA Module F - 51
F
3.75G/HSPA Module
If you have included an optional 3.75G/HSPA (High Speed Packet Access) module
(see “Communication” on page D - 5 for specification details) in your purchase op-
tion, you will have the appropriate software provided for your module. Follow the
instructions on page 7 - 17 to install the USIM card (supplied by your service provid-
er), and then install the appropriate application.
Before installing the application, make sure that the 3.75G/HSPA module is on. Use
the Fn+() key combination (see “Function/Hot Key Indicators” on page F - 6)
to toggle power to the 3.75G/HSPA module.
3.75G/HSPA Module
Options
There are three option-
al 3.75G/HSPA mod-
ules available for this
series of computer mod-
els. Each module is sup-
plied with the
appropriate application
software.
The module type sup-
plied may depend upon
the computer model pur-
chased. Check with your
service center for de-
tails.
Install the driver from
the Drivers Installer
menu and check the in-
structions for the appro-
priate application on the
following pages.
Important Notice - 3.75G/HSPA & Bluetooth/Wireless LAN Modules
In order to comply with FCC regulations you should NOT operate the 3.75G/HSPA module
and the Bluetooth/Wireless LAN modules at the same time as this may disrupt radio fre-
quency, and cause interference. When the 3.75G/HSPA module is powered on, make sure
that the Bluetooth/Wireless LAN modules are powered off.