Modules & Options
3.75G/HSPA Module 7 - 17
7
For Models A - D
1. Turn off the computer, and turn it over and remove the battery.
2. Locate the SIM card cover and loosen screw .
3. Remove the SIM card cover .
For Models E - F
1. Turn off the computer, and turn it over and remove the battery.
2. Locate the RAM & CPU bay cover and remove screws
- .
3. Carefully (a fan and cable are attached to the under side of the cover) lift up
the bay cover.
4. Carefully disconnect the fan cable , and remove the cover .
Power Safety
Warning
Before you undertake
any installation proce-
dures, make sure that
you have turned off the
power, and disconnect-
ed all peripherals and
cables (including tele-
phone lines). It is advis-
able to also remove your
battery in order to pre-
vent accidentally turning
the machine on.
Figure 7 - 9
SIM Card Cover/
RAM & CPU
Bay Cover Removal
1
2
3 5
6 7
2
1
Models E & F
3
4
5
Models A - D
7
6
Fan Cable
Make sure you re-
connect the fan cable
before screwing
down the bay cover.
6
To Next Page
Loading...
