GEOFE:PROG,1111,2,4,11,11,22,22,33,33,44,44
Disables, or enables GeoFencing and sets the operational area of
GeoFencing.
Parameter 1: 0-2, 0 = disable, 1 = circle, 2 = polygon
Parameter 2:
a. If Circle is selected in Parameter 1, enter the location
coordinate of the center of the circle.
Latitude: -90 to 90
Longitude: -180 to 180
b. If Polygon is selected in Parameter 1, select the vertex
number of the polygon: 3 = 3 vertices, 4 = 4 vertices.
Parameter 3:
a. If Circle is selected in Parameter 1, enter a radius between
200 and 10,000 meters.
b. If Polygon is selected in Parameter 1 and the vertex number
determined in Parameter 2, enter the location coordinates
(latitude and longitude respectively).
- If 3 vertices are selected, enter 3 sets of coordinates.
- If 4 vertices are selected, enter 4 sets of coordinates.
E.g.: GEOFE:PROG,1111,0 for disable
E.g.: GEOFE:PROG,1111,1,12,123,200 for circle
E.g.: GEOFE:PROG,1111,2,3,11,11,22,22,33,33 for polygon vertex of
3
E.g.: GEOFE:PROG,1111,2,4,11,11,22,22,33,33,44,44 for polygon
vertex of 4
Both Latitude and Longitude accept coordinates of up to 6 decimal
points. Due to the mechanics of GPS positioning, the 6th decimal
point may deviate slightly from the entered value. However, the actual
position is affected very slightly.
FWUG:PROG,1111,59.124.230.221,53033,/img/123.bin,042d
Upgrade Mobile Lite firmware by downloading firmware file from
server remotely.
Parameter 1: Server IP Address (Max 44 characters)
Parameter 2: Server Port Number
Parameter 3: File path(max 31 characters)
Parameter 4: crc16 check sum
To Next Page
Loading...
