56
384 – RF Device Low on Battery (status)
When the learnt-in RF Fall Sensor, WTR, Panic Button, or PCU is low
on battery.
602 – Auto Check-In Report (status)
When Mobile Lite makes an auto check-in report to the CMS.
The Mobile Lite location info will be updated and sent with the auto
check-in report to CMS.
645 – Locate Position Follow Up After Alarm (emergency)
When an alarm is triggered, if new location could not be acquired
before the alarm report is made, Mobile Lite will report the alarm event
code first then follow up with event code 645 to report new location.
If location update failed during two-way communication, Mobile Lite
will follow up with event code 645 to report updated location.
646 – Location Positioning Command (status)
When Mobile Lite receives the SMS command “LOC” to report its
location, the report is sent with event code 646.
648 – Location Scream (status)
When a user requests Mobile Lite to scream, the Mobile Lite will beep,
and location will be reported.
671 – GeoFencing Action (status)
When Mobile Lite leaves the programmed GeoFence area. The
location info will also be sent
When Mobile Lite makes continuous GPS report after GeoFence Alert.
7.3. SIA Digital Communication Standard
Please refer to the document SIA Digital Communication Standard – Internet
Protocol Event Reporting (ANSI/SIA DC-09-2012A) published by the Security
Industry Association for details. Examples of events reported in the SIA/CID
format are as follows:
<LF>16680081"ADM-CID"0009L0#41770744318[#41770744318|1101 00
200][X006E33.66754530][Y46N31.02882385][P0,b:100%,d:0,g:4,t:201908151
00017,la:1,c:0,by:G]<CR>
Where:
“ADM-CID” means that the content of this message is in the CID format.
0009 for <seq>
L0 for <Lpref>
#41770744318[#41770744318|1101 00 200]
41770744318 = account number
To Next Page
Loading...
