HOW TO RECORD VIDEOS TO THE USB/SD STORAGE DEVICE?
3.1 Connect
1. Connect the video player to IN port on ClonerAlliance ViewPro via an HDMI cable. Note: For AV/VGA/YPbPr source
devices, please use the included MMI cable and connect it to the MMI port on ViewPro. After connections, please use
the signal buttons on the remote or the “Source”button on ViewPro device to select the correct input signal.
2. Plug the USB storage device or SD Card into ClonerAlliance ViewPro.
3. Plug the power adapter into the power socket and plug the other end into the 12V port of ClonerAlliance ViewPro. Or
install batteries into the device for power supply.
4. Power on ClonerAlliance ViewPro after all devices and cables are well connected.
Tips:
If you want to monitor the output image on TV, you can connect ClonerAlliance ViewPro from OUT port to TV via an HDMI
cable. Please note that the output image will either display on the screen of ClonerAlliance ViewPro or the TV, it can NOT
display on both at the same time.
14
To Next Page
Loading...
