HOW TO PLAYBACK THE RECORDED FILES ON
CLONERALLIANCE VIEWPRO?
4.1 Playback the Recorded files on ViewPro directly
• Connect
1. Plug the USB storage device or SD card into the “Storage”port of ClonerAlliance ViewPro.
2. Plug the power adapter into the power socket and plug the other end into the 12V port of ClonerAlliance ViewPro. Or
you may install batteries into the device for power supply.
Note:
If you use a TV for monitoring during recording videos and you want to playback the recorded files on the TV after recording,
please note that the LCD screen of ClonerAlliance ViewPro will remain off in the whole process, this is normal and does not
indicate a defective unit. The videos can be played either on the screen of ClonerAlliance ViewPro or on the TV when these
two devices are connected. It can NOT display on both at the same time.
26
To Next Page
Loading...
