Cloos GLC 503 MC3 - Page 45

B-27
Programming
GLC 353/503/553 MC3
When all values have been
set, the operation panel
shows the following:
- Turn Potentiometer 1 and 2 at the
Wire drive unit to mid-position.
- Press the key Operating mode for
more than 1 second.
- The first program step to be made is
setting of Gas preflow.
Actuate the keys Up
or Down until the required
value has been set.
- Press and release the key Operating mode.
The next program step
Wire Inching can be entered.
Actuate the keys Up
or Down until the required
value has been set.
For robotic operation:
The inching-in value is used as
set value, if the command "Wire
by hand" (currentless wire
advance) is given and an external
control voltage is not available.
4
2
4
2
P4 Programmieren eines Schweißprozessablaufs
5