B-41
Options
GLC 353/503/553 MC3
O Options
The power source GLC 353/503/553 MC3 can be equipped with the following options:
- Key-operated switch
- Serial interface
- Remote controller - connected at CK 98 A -
- Automation interface
These options are described below.
O1 Key-operated switch
The installation of a key-operated switch enables to protect the memory contents of
welding procedures against modifications.
This means : It is impossible to save modifications.
O2 Serial interface
The serial interface enables to connect the power source to a PC or laptop, where the
PC-Software MC3 program developed by Cloos is installed. This option enables the
following functions:
- Save characteristic curves and welding processes in the PC
- Transmit characteristic curves and welding processes to the power source
- Generate characteristic curves
- Print characteristic curve data
O1 Key-operated switch O2 serial interface
To Next Page
Loading...
