8
GLC 353/503/553 MC3Operating instructions
As there are several versions of pacemakers, the
situation must be clarified with the relevant
pacemaker manufacturers or their representatives
(hospital etc.).
— Switch off the welding machine when not in use
to prevent any electrical risk.
Warning! The terminal voltage of the welding
machine may be up to 113V= or 48V~!
— If you have to stand on metal or in a wet area
during welding, insulation with suitable dry
materials is required.
— Avoid contact with wet or conductive metal parts;
wear dry clothing.
— Always maintain correct insulation of cables,
plugs and welding torches. Do not overload
these parts.
— Keep everything dry, including clothing, welding
area, cables and welding machine. Repair
immediately any faulty water cooling lines.
— Welding machines may only be used if all covers
are present and correctly installed.
— Although the machine is marked “S” (approved
for welding in environments with increased
electrical hazard), the power source itself may
not be installed here, because of the mains
voltage of 400 V; only the welding torch and the
wire drive unit are permitted at such places.
— Before any work is carried out inside the power
source, the mains switch must be switched-off
and the mains plug disconnected.
After disconnecting the mains plug, wait at least
2 minutes until the capacitors have reached safe
values.
— Be careful when changing the wire coils. Switch
off the machine so that the switching command
cannot be initiated.
— Lock the wire coil holder, by turning the locking
button to prevent the wire coil becoming loose.
To Next Page
Loading...
Need help?
General
