MAN.219 Rev.8 ENG - Use and maintenance manual S19N page 53 of 71
The following material must be subjected to differentiated disposal and
then positioned in suitable premises and containers:
▪ Ferrous materials: carpentries and mechanical components.
▪ Plastic materials: gaskets, belts, protections.
▪ Electrical materials: windings, commands, solenoid valves and simi-
lar.
▪ Oils and lubricants: hydraulic oil, reducers lubricants, lubricating
greases.
8.15 Service
For repairs and maintenance of your platform, ex-
clusively contact:
Service
C.M.C. s.r.l.
Via Bitritto, 119
70124 BARI – ITALY
Tel. +39 080 5326606
+39 080 5326557
Fax: +39 080 5368541
E-mail: info@cmclift.com
IMPORTANT NOTE:
FOR ANY COMMUNICATION, PROVIDE THE TYPE AND SERIAL
NUMBER OF THE MACHINE.
During the technical assistance, you will be requested to read the failure
code on the display mounted on the turret, shown in Picture 79:
Picture 79: machine state code display
Any operation requiring interventions on the components of the ma-
chine shall be carried out by authorized and trained staff.
Non-authorized staff can’t replace components. Many components
of the MEWP have been calibrated: a correct calibration of
these parts (which is possible only in C.M.C. or in authorized
workshops) is necessary to ensure the safety of the machine.
8.15.1 Remote Connection System (*optional)
The remote connection system is composed of an electronic box (Picture
80) mounted on the chassis box, as *optional, to enter into the machine
logic system.
To Next Page
Loading...
