CMC S28 User Manual

MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 102 of 138
8.5 Maintenance after the first 400
hours
Operations
by
Replacement of the hydraulic filters.
USER /
CMC
Registration of the movement of the arms.
CMC
8.6 Six-monthly maintenance (or
every 750 hours)
Operations
by
Replacement of the hydraulic filters (25
micron).
USER /
CMC
Complete check of the whole machine
and note the results in the appropriate
manual section.
USER /
CMC
8.7 Annual maintenance (or every
1500 hours)
Operations
by
Replacement of hydraulic oil.
CMC
The MEWP is equipped with a pressurized oil tank
capable of always keeping constant the pressure inside
the hydraulic circuit. In case you want to open the tank to
top up oil or perform an inspection, follow the procedure
below:
1. Place the MEWP in transport configuration;
2. Unscrew the tank cap (Picture 113);
3. Suck the oil from the tank;
4. Open the filter tap by a key;
5. Dismantle and replace the old hydraulic filter
with a new one with a 25 micron filtration
degree;
6. Fill the tank with the new oil until the maximum
level indicator.
The oil control levels can be monitored thanks to a level
indicator placed on the side of the tank.
Warning! The hydraulic circuit is pressurized
(max. 1,1 bar at strainer waste).

CMC S28 Specifications

General

Brand	CMC
Model	S28
Category	Boom Lifts
Language	English