MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 46 of 138
4 Use procedures
4.1 General safety rules
The operation of the MEWP must take place in
compliance with the international reference
standards. The operator must read,
understand and follow all the warnings and
instructions for the safe use of the MEWP, that
are contained in this manual or decals affixed
to the machine.
THE NON-COMPLIANCE WITH THE SAFETY
PRECAUTIONS LISTED IN THIS SECTION AND
REPORTED ON THE MACHINE MAY CAUSE
PERSONNEL INJURY OR DEATH AND
DAMAGE TO THE MACHINE AND IS A
SERIOUS INFRINGEMENT OF THE SAFETY
REGULATIONS.
Avoid wearing loose clothing, rings, watches or anything
else that can get caught in moving parts. During the use
of the machine or the maintenance, wear hats, safety
glasses and shoes, gloves and earmuffs (after having
controlled their integrity) and any other Protective
Personal Equipment that the security manager evaluates
necessary according to risk analysis performed by him.
4.2 Environmental operational
conditions
The equipment can work normally in the following
environmental conditions (for uses in different
conditions, a special equipment is required):
o temperature from -25 °C (-13 F) to +55 °C (131 F)
(even +70 °C (158 F) for short periods which do not
exceed 24 h);
o humidity from 30% to 90% (at 20 °C);
o max wind speed 12,5 m/s (45 Km/h - 27.96 mph).
Do not cover the equipment with cloths in order to
avoid condensation inside the electrical boards.
After storage in closed and very wet places for a long
period, the machine could have some problems due
to condensation in the electrical boards: in this case,
please contact the Technical Assistance Service
before use.
Do not operate in areas with dangerous
environmental conditions: poor visibility,
storms, lightning risk, etc.
To Next Page
Loading...
Need help?
General
