MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 6 of 138
1 Description and
purpose
1.1 Machine definition
The machine is called S28 and it is a mobile
elevating work platform (MEWP):
• machine/device intended for moving persons,
tools and material to working positions, consisting
of at least a work platform with controls, an
extending structure and a chassis (ANSI/SAIA
92.20 par. 3);
• mobile machine intended to move persons to
working positions, where they are carrying out
work from the work platform, with the intention that
persons are getting on and off the MEWP only at
access positions at ground level or on the chassis
and which consists as a minimum of a work
platform with controls, an extending structure and
a chassis (EN 280 par. 3.1).
It is forbidden to use the MEWP with
methods and/or conditions other than those
specified and approved by the
manufacturer.
1.2 Machine purpose
The MEWP S28 is a machine which enables the
operators to reach the working place when this is high
positioned.
The machine has been designed for an essentially
vertical use. It must be travelled only when it is totally
folded in the transport position.
➔ The use of the machine is allowed only to
professional staff, properly trained and
specialized.
1.3 CE certification
C.M.C. s.r.l. states under its own responsibility that S28
was designed and produced in compliance with
national and European standards, and that the
machine is identical to the model submitted to control
and test for the “CE certification” by the Notified
Institute nr. 1878 - VERICERT s.r.l. - via L. Masotti, 5
- 48124 Fornace Zarattini (RA) - Italy.
A copy of the CE Certificate is attached to the manual.