MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 104 of 138
➔ To ensure the safety of the machine the use of
original spare parts installed by C.M.C. or by
authorized repair shops is compulsory: in fact,
some components can be calibrated only c/or
C.M.C. or in authorized workshops.
It is forbidden to perform maintenance
operations when the MEWP moves: make sure
that the parts to maintain are motionless and do
these operations with the motor of the chassis
stalled, taking the keys away from the panel;
➔ Perform the maintenance operations in a sufficiently
large space and suited to the sizes of the truck: mark
the area assigned for the maintenance operations
by suited enclosure or by a red/white band ribbon
and do not allow entrance to unauthorized staff.
➔ Do not modify or remove safety devices.
➔ Do not modify calibrated pieces.
➔ During the washing operation, do not lead the water
jet directly on the electrical panels of the MEWP and
do not use cleansing, aggressive chemicals
dangerous for the components of the MEWP (rubber
parts, painted parts, etc.).
It is forbidden to perform any intervention on
parts of the MEWP, such as welding, piercing,
and so on, without prior written authorization by
C.M.C.
➔ Wear appropriate protective clothes (gloves,
goggles, etc.).
➔ During maintenance operations, be careful not to
damage the hydraulic circuit and avoid impurities in
the circuit.
➔ Before any maintenance operation that involves the
disassembly of hydraulic circuit parts, make sure
that the system is not under pressure. In order to
avoid violent emissions of oil, move all the levers of
the control distributors, with the truck motor stalled
and no component in movement.
8.11 Maintenance of endothermic
engine
The standard supplied motor has the following technical
characteristics:
o diesel engine KUBOTA D902-E4B (3 cylinders,
four-stroke vertical heated to water):
To Next Page
Loading...
Need help?
General
