MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 110 of 138
Picture 114: remote connection system.
Following the remote connection procedure:
1. Ensure that the M12 socket on the remote
connection box is correctly connected to the M12
plug of the electric box mounted on the chassis.
2. Share your internet wireless network with the
remote connection device in free mode (without
password).
3. Lift the connection remote switch L under the red
cap on the switching on/off box (Picture 115):
Picture 115: chassis box.
o the led on the remote connection box makes
two red flashes,
o after 30 seconds, the led becomes fixed and
green, to show that the operating system is
working,
o it automatically hooks up to your free network;
4. Install on your PC the TeamViewer software (11
th
version) to connect to the machine system, through
ID and Password supplied by the manufacturer;
5. Call C.M.C. Service for technical assistance.
To Next Page
Loading...
Need help?
General
