CMC S28 User Manual

MAN.243 Rev.5 ENG - Use and maintenance manual S28 page 81 of 138
• Do not disassemble any covers or protective
cases.
• Do not use chemical cleaners or petrol which
would cause serious damage to plastic
components and paintwork.
• Remove the remote control and correctly close
the connection sockets of the remote control and
/ or equipment placed on the machine, before
washing operations.
Before washing, set the MEWP in driving position.
In addition, stall the engine, take off the batteries
and remove the ignition key. During washing, the
machine must be turned off and disconnected
from the power supply.
The more you clean the MEWP, the more you have
to lubricate it.
Cleaning the electrical/electronic parts with water
is prohibited. Failure to comply with this
requirement can cause serious damage to the
system electric machine.
To clean electrical parts, use only dry cleaners.
• Dry the machine thoroughly before turning it on
again (for example with compressed air).
• Make sure that moisture has not entered the
electrical engine or other parts of the electrical
system.
4.9.3 Prevention against electric lightning
stroke
If you need to work with the machine near power lines,
the user is obliged to keep an adequate distance.
Below there are the minimum safety distances to be kept
by qualified staff according to their type of voltage:
Voltage field of electric
line
Minimum safety
distance
Up to 300 V
Avoid contact
300 V < x > 750 V
1 ft. 0 in. (30,5 cm)
750 V < x > 2 kV
1 ft. 6 in. (46 cm)
2 kV, < x > 15 kV
2 ft. 0 in. (61 cm)
15 kV < x > 37 kV
3 ft. 0 in. (91 cm)
37 kV < x > 87.5 kV
3 ft. 6 in. (107 cm)
87.5 kV < x > 121 kV
4 ft. 0 in. (122 cm)
121 kV < x > 140 kV
4 ft. 6 in. (137 cm)

CMC S28 Specifications

General

Brand	CMC
Model	S28
Category	Boom Lifts
Language	English