Page | 12
WARNING!
Do not disturb the Accessport and the OBD-II connector while installation is taking place.
Failure to do so may result in incomplete ECU reprogramming which will render the vehicle
inoperable. If an error occurs during the reflash, the Accessport will enter Recovery Mode
and attempt to recover the reflash.
Installation Complete
Follow all on-screen prompts on the Accessport to complete the installation process. The Accessport is
now fully installed and ready for use and the vehicle's ECU and TCM, if applicable, are now
programmed with new calibration data. The Accessport does not need to be plugged into the vehicle
for the calibration to be in effect. You can disconnect the Accessport at this time or leave it plugged in
to use any of the many features outlined below.
Please note that the Accessport is designed to work with only one vehicle at a time. Once the
Accessport is installed, it cannot be used with another vehicle until it is uninstalled from the
original vehicle.
To Next Page
Loading...
