Page | 19
Performance
The Accessport can calculate several performance measurements.
NOTE: The Accessport is only capable of calculating performance test results while the ignition
is turned to the “ON” position. The Accessport will display an error message if it cannot
communicate with the vehicle.
0-60 MPH
To record the 0-60 MPH performance, select this menu option and follow the on-screen instructions. A
time slip showing the performance results will be displayed at the end of the performance test.
¼ Mile
To record the ¼ Mile performance, select this menu option and follow the on-screen instructions. A time
slip showing the performance results will be displayed at the end of the performance test.
Dynamometer
Use this feature to estimate your vehicle's wheel horsepower and torque. This can be used to see the
actual performance gains of part upgrades.
NOTE: You will be prompted to enter a vehicle weight, test gear, and RPM range for the test. This
data will be stored for future use.
Press [UP] to find the Setup option for Performance where you will find the following options:
Change Units
Metric – This unit scheme uses metric units: C, kph, kPA, Lambda
Metric w/ AFR – This unit scheme uses metric units (excl. AFR): C, kph, kPA, AFR
Imperial – This unit scheme uses imperial units: F, mph, PSI, AFR
To Next Page
Loading...
