Page | 22
Tune
Change the performance of your car.
Adjust LC RPM (AP3-NIS-006 and AP3-NIS-008 only)
This option can be found in the Available Adjustments menu and allows the Launch Control RPM to be
adjusted. In order to use this feature, you must use a map created using Accesstuner v1.9.1.0-8151 (or
newer). Simply opening your existing maps and re-saving them with this version of Accesstuner will
suffice. To adjust Launch Control RPM, enter the Tune menu, slect “Available Adjustments”, then select
“Adjust LC RPM”. Press the OK button, then use the UP/DOWN arrows to raise or lower the LC RPM in
increments of 100; press OK again to save your setting.
NOTE: Changing your ECU map or switching to a different map slot will reset your launch control RPM
to the default settings.
NOTE: User adjustable Launch Control currently only supports LC4 and LC5.
Switch Traction Control
This option can be found in the Additional Adjustments menu and allows you to switch between a
predetermined amount of slip. Traction Control adjustments are disabled by default and requires custom
tuning via Accesstuner Pro or Accesstuner Race.
Change Map
To change the mapping on your ECU, select this menu option and follow the instructions. The ignition
must be turned to the “ON” position during the Change Map operation. You will be prompted to select a
pre-loaded map. The same warning that applies to the installation process applies here as well (battery
charge level, turn accessories off, climate control turned off, etc.)
NOTE: If you wish to see a longer description for the highlighted map, press and hold the [OK]
button on the desired map.
To Next Page
Loading...
