DIGIMINI EMEA/APAC/AUSTRALIA REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 11-Oct-15 www.cobham.com/wireless
Document number: 00030UMCD Rev. 5.0
Page | 5-1
5 SETUP AND CONFIGURATION
NOTE: This section is relevant to installations that do not include DMCU. For installations with DMCU
unit, refer to the DMCU User Manual.
The Mini-Repeater is designed for simple plug-and-play operation, only requiring the setup of a
number of parameters (such as DL Output Power, bandwidth, and gain) through a local Web
connection and verifying that the system is operating properly.
The setup procedure consists of the following steps:
1. Open a local Web session to the Repeater.
If you are not familiar with the Cobham Wireless Web Access application, it is recommended to
quickly review the Navigating the Web GUI Application section.
2. Adjust the signal levels and configuring the sub-bands and verify that no Alarms are generated.
5.1 Open a Direct Local Web Session to the
Repeater
NOTE: These instructions are valid only for installations
without
a DMCU.
The procedure consists of three steps:
• Connect the setup computer to the repeater’s Ethernet port.
• Configure the computer’s IP address to be in the same subnet as the repeater’s IP Address
• Login to the repeater
To Next Page
Loading...