COBHAM EXPLORER 8000 Series User Manual

Introduction
98-145510-E Appendix D: Command line interface D-2
Telnet
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet session
do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, default login admin and default
password 1234.
D.1.2 Help
If you enter help directly at the prompt UCLI:/$ all available commands are listed.
Additionally any command will take help as first argument and display detailed
information of the specific command.
D.1.3 Conventions
The command description below uses the following special typography:
Example: satellite lon [longitude]
zone <id> active <yes | no>
Figure 2: Command line interface, login
Convention Description
Courier font Information that is displayed on the screen.
Bold Courier font Text the user must enter.
<argument> Required argument
[argument] Optional argument
Table D-3: Command typography

COBHAM EXPLORER 8000 Series Specifications

General

Brand	COBHAM
Model	EXPLORER 8000 Series
Category	Marine GPS System
Language	English