Software update
98-145510-E Chapter 7: Service and maintenance 7-4
7.2 Software update
7.2.1 Prerequisites
The following items are required to make a software update:
•One computer with a standard Ethernet port available.
• A standard Internet browser.
• 1024 × 768 pixels or higher display resolution (best viewed with small fonts).
•One straight LAN cable.
• Access to the file with the new software.
7.2.2 Software update procedure
To update the VSAT system software
The antenna software is automatically updated when the ACU software has been updated.
1. Power up the VSAT system, i.e. switch on the ACU.
2. Connect a PC to LAN interface 1 (Service port, standard Ethernet).
If you want to use another LAN port to access the web interface you must configure it
according to your network requirements. See To configure the LAN network on page 6-
14 for more information.
3. Open your Internet browser and enter the IP address of the VSAT system. The default IP
address is http://192.168.0.1.
4. Type in the user name admin and the password 1234 to access the Dashboard.
5. The web interface shows the DASHBOARD page.
6. Click SERVICE in the navigation pane.
The UPLOAD page is displayed.
Software update should only be done by qualified service personnel.
To Next Page
Loading...
Need help?
General
