98-145510-E iii
Safety summary
The following general safety precautions must be observed during all phases of operation,
service and repair of this equipment. Failure to comply with these precautions or with specific
warnings elsewhere in this manual violates safety standards of design, manufacture and
intended use of the equipment, and will void the warranty. Thrane & Thrane A/S assumes no
liability for the customer's failure to comply with these requirements.
Power supply
The voltage range for the EXPLORER 8000 series is 100 – 240 VAC (nominal), 50/60 Hz. The
socket-outlet shall be installed near the equipment and shall be accessible. See also System
power supply range (input via ACU) and Total system power consumption on page A-1.
Grounding
Do not operate in an explosive atmosphere
Keep away from live circuits
Operating personnel must not remove equipment covers. Component replacement and internal
adjustment must be made by qualified maintenance personnel. Do not replace components
with the power cable connected. Under certain conditions, dangerous voltages may exist even
WARNING! Heavy weight - Do not attempt to lift the antenna alone! Use
two or more persons or a lifting device. The antenna can weigh up to 70 kg and
is difficult to handle.
WARNING! Hazardous moving parts - keep fingers and other body parts
away from the antenna while the system is powered!
WARNING! Be aware of pinch points while the antenna is being positioned,
deployed or stowed.
WARNING! Before disassembling or performing any maintenance or upgrades,
unplug the unit from the power source.
WARNING! Always connect your ACU to the safety ground of your
power source (e.g. generator, inverter, line outlet etc.).
WARNING! Do not operate the equipment in the presence of flammable gases
or fumes. Operation of any electrical equipment in such an environment
constitutes a definite safety hazard.
To Next Page
Loading...
Need help?
General
