COBHAM EXPLORER 8000 Series User Manual

Lists of events
98-145510-E Appendix E: System messages E-2
E.2 Lists of events
E.2.1 ACU events
Note
These lists include event messages for other products as well as the
EXPLORER 8000 series, so some of the listed event messages may never appear in
your VSAT system.
Error
code (ID)
Severity Description Explanation
08060-0 WARNING Antenna modem ACU/Antenna communication error detected (framing
and parity). If the situation is persistent, check if cable
specifications comply (length and attenuation).
08061-0 WARNING VMU linux shell
password
The specified password (root) for the satellite modem is
not accepted by the modem.
08062-0 WARNING VMU debug shell
password
The specified password (user) for the satellite modem is
not accepted by the modem.
08063-0 ERROR Antenna connection The ACU has lost connection with the antenna.
08064-0 ERROR ADM PLL lock The intermediate frequency PLL is not in lock. Check the
10 MHz reference signal.
08065-0 WARNING GNSS data Missing GNSS data (fix).
08066-0 WARNING Heading data Missing heading information. Check cable and heading
provider device.
08067-0 ERROR PCB temperature ADM temperature too high. Make sure there is
compliance with the environmental specifications.
08068-0 ERROR PSM power The PSM fails to provide the requested supply voltage.
08069-0 WARNING Blocking Zone The antenna has entered a blocking zone.
0806A-0 WARNING VMU connection The ACU has lost connection to the satellite modem.
0806B-0 WARNING ROSS connection The ACU has lost connection with the ROSS device.
0806C-0 ERROR VMU frequency setup There is a mismatch in the frequency setup. Probably
the satellite modem is not configured correctly to match
the requirements of the ACU and antenna. A common
mismatch is the absence of Rx or Tx LO parameter in the
satellite modem.
Table E-1: Event messages for ACU

COBHAM EXPLORER 8000 Series Specifications

General

Brand	COBHAM
Model	EXPLORER 8000 Series
Category	Marine GPS System
Language	English