COBHAM EXPLORER 8000 Series User Manual

Supported commands
98-145510-E Appendix D: Command line interface D-4
D.2.4 antenna_data
Command Description
antenna_data
Shows the sub commands, unit and description for the command
antenna_data
antenna_data select
[pcm | backup]
Use antenna data from the specified unit.
To copy antenna data from the PCM to the ACU and use these as
primary data, enter:
antenna_data select pcm
antenna_data buc
Shows the 1 dB compression point in 1/100 dBm and the BUC gain
in 1/100 dB.
antenna_data buc
[<type> [<parameters>]]
Sets the BUC type, 1 dB compression point in 1/100 dBm and the
BUC gain in 1/100 dB.
Valid range:
<type> = std8W, std20W or custom
<parameters> = <power_source> <1dB_compress>
<buc_gain>
• <power_source>: 0 (N-connector), 1 (M&C
connector) or 2 (Disabled)
• <1dB_compress>: 3000-5000 (30-50 dBm)
• <buc_gain>: 2500-8000 (25-80 dB)
Example: To set the BUC type to the standard 8W BUC, the
BUC power source to N-connector, the 1 dB
compression point to 39 dBm and the BUC gain to 65
dB, enter the following command:
antenna_data buc std8W 0 3900 6500
antenna_data lnb
Shows the lnb settings
Table D-7: UCLI command: antenna_data

COBHAM EXPLORER 8000 Series Specifications

General

Brand	COBHAM
Model	EXPLORER 8000 Series
Category	Marine GPS System
Language	English