COBHAM EXPLORER 8000 Series User Manual

Description of the system components
98-145510-E Chapter 2: Introduction 2-8
Web interface for setup and troubleshooting
To fully configure the VSAT system, use a computer with a standard Internet browser to
access the built-in web interface.
The web interface is mainly used for calibration of the system, first-time setup of satellite
and modem profiles, setup of the LAN ports, WLAN use and administrating admin and guest
access rights. You can also deploy, stow and stop the antenna, and monitor the system
(warnings, errors and information) with the web interface.
The web interface can be accessed using LAN or WLAN, if configured. see WLAN settings
on page 6-16. Note that you must use the LAN connection when you first configure the
WLAN interface.
To access the web interface:
1. Connect your computer to the LAN 1 or WLAN interface. For details on LAN/WLAN
interface setup see To configure the LAN network on page 6-14.
2. Enter the IP address for the web interface. The default IP address is http://192.168.0.1.
For details about further configuration and use, see Setup and operation on page 6-1.
Figure 11: Web interface, DASHBOARD (example, EXPLORER 8100 Ku-Band)

COBHAM EXPLORER 8000 Series Specifications

General

Brand	COBHAM
Model	EXPLORER 8000 Series
Category	Marine GPS System
Language	English