Codan X-2 - Page 6

iv Table of Contents X-2 Technical Service Manual
Publication No: 15-02047
7.12.4 Selectivity (USB operation)......................................................7-13
7.12.5 Clarifier Operation....................................................................7-14
7.12.6 Noise Limiter Operation ...........................................................7-14
7.13 Transmitter Performance Checks ...................................................................7-14
7.13.1 Frequency Check......................................................................7-14
7.13.2 ALC.........................................................................................7-15
7.13.3 Power Output and Intermodulation...........................................7-15
7.13.4 Emergency Call ........................................................................7-15
8 Appendices.........................................................................................................8-1
Appendix A: Connectors ..........................................................................................8-1
A.1 Microphone................................................................................8-1
A.2 External Loudspeaker.................................................................8-1
A.3 Antenna Control.........................................................................8-2
A.4 Programming Cable ....................................................................8-2
A.5 Cloning Cable.............................................................................8-2
Appendix B: Parts Lists............................................................................................8-3
B.1 General Information....................................................................8-3
B.2 Ordering Information..................................................................8-4
B.3 Component Substitution .............................................................8-4
B.4 Parts Lists...................................................................................8-4
Appendix C: Engineering Drawings........................................................................8-23
Appendix D: Glossary of Terms..............................................................................8-25
D.1 Abbreviations ...........................................................................8-25
D.2 Abbreviations of Units..............................................................8-26
D.3 Abbreviations of Unit Multiples ................................................8-27