• If the device is smoking or making unusual sounds, power off and unplug the device
immediately.
• Do not insert foreign objects of any kind into the device; doing so can constitute a safety
hazard and cause extensive damage.
• Do not place any liquid containers on the device. If, for some reason, liquid seeps into the
device, power off the device and unplug the power cord from the source outlet. If used
without taking corrective measures, the device may be damaged.
• Do not expose the device to flammable gases in concentrations high enough to cause fire
or explosion.
Location Precautions
• The operating ambient temperature range of SLS PCS is 15–30ºC (59–86ºF), with a relative
humidity of 20%–80%.
• If SLS PCS is moved quickly from an extremely cold location to a warmer one,
condensation is likely to form. Do not use SLS PCS if condensation has formed.
• Wait until the condensation has evaporated. You can speed up the evaporation time by
moving SLS PCS to a dryer location.
• Do not place SLS PCS in a location with high humidity or high dust. Airborne dirt particles
can cause print quality problems. Avoid placing SLS PCS in locations where ventilation
ducts, open doors, or frequent passers-by might expose SLS PCS and labels to high levels
of debris.
• Do not locate SLS PCS in hot-springs areas where hydrogen sulfide and acidic ions are
likely to be generated.
• Do not locate SLS PCS where there are oily fumes and vapors.
• Do not locate SLS PCS in direct sunlight.
• Do not locate SLS PCS near sources of high RF energy.
• Do not locate SLS PCS where it might be subject to jarring or vibrations, such as a table or
desk in a high-traffic area. Jarring and vibrations can affect the print quality of labels.
• If using a VESA mount to mount the device on a wall, stand, or anesthesia supply cart,
refer to the VESA Mounting Interface Standard (MIS), available at www.vesa.org, for proper
location and installation information.
Cleaning Precautions
To avoid damage to the device, observe the following general precautions for cleaning
the device:
• Apply the cleaner to a clean, lint-free cloth first and then clean the device.
• Liquid applied directly to the device could possibly leak inside the device and cause
damage. Use extra caution when cleaning around the vents on the back of the
touchscreen and speaker.
• Allow the device to completely dry before operating it again.
• Many plastic components are used in SLS PCS construction. Coat flecking and
deformation is likely to occur if the device is wiped with chemical dusters, benzene,
thinners, insecticides, or other solvents. Rubber and PVC materials left in contact with
To Next Page
Loading...