COFFEtek VITRO RANGE - DAILY HYGIENE; Cleaning Instant Units; Cleaning The Coffee Brewer

17 OPERATORS MANUAL VITRO LINE
DAILY HYGIENE
Cleaning Instant Units
 Set the On/Off switch on the machine to ON.
 Remove the instant ingredient canisters. Wipe clean the exterior surfaces of the canister
assembly. Wipe dry.
 Remove the coffee grouts bucket. Empty the contents of the bucket and wash and dry it.
 Remove the waste tray and grille. Empty the contents of the tray and wash and dry the
tray and grille.
 Put a container of at least 300ml capacity under the dispensing nozzles.
 Press the FLUSH button once on the internal keypad. The screen will ask if you wish to
flush the espresso system. Press UP several times until it shows FLUSH INSTANT. Press
ENTER
 The machine will run warm clean water through the instant bowl whilst running the whipper
motor. This process will clean any residual product that has been left in any of the
systems.
Once again remove the coffee grouts bucket. Empty the contents of the bucket and wash
and dry it then refit into the machine.
Note: Some of these operations should only be performed in machines that incorporate tea
or coffee brewers or espresso group brewers. If your machine doesn't incorporate this
elements, perform the next step.
Cleaning The Coffee Brewer
 Set the On/Off switch on the machine to OFF and isolate the mains electrical supply from
the machine. Unlock and open the cabinet door.
 Remove the ingredient canisters. Wipe clean the exterior surfaces of the canister
assembly. Wipe dry.
 Remove the waste tray and grille. Empty the contents of the tray and wash and dry the
tray and grille.
 Remove the coffee grouts bucket. Empty the contents of the bucket and wash and dry it.
 Disconnect the tube connecting the coffee brewer to
the mixing bowl by pulling the black right-angled fitting
(A) away from the brewer itself. Remove the coffee
brewer safety cover and lift the lower carriage locking
lever (B) to the vertical, (unlocked position). Remove
the carriage assembly by pulling it gently towards the
front of the machine.
 Disconnect the ball and socket coupling visible inside the coffee brewer extract chamber.
This is accomplished by pulling the lower vertical rod towards the front of the machine.
A
N
a
B
N
a
t