10
Removing the Intermediate Frame
Using a small straight tip screwdriver, free the ten
locking tabs which secure the intermediate frame to the
main frame and remove the intermediate frame. On early
units with a position sensor, it is necessary to remove the
position sensor from the intermediate frame. Use a small
straight tip screwdriver to remove the position sensor
cover from the intermediate frame and remove the
position sensor.
NOTE: Units beginning with serial #109300187 or later
do not have a bill position sensor.
SECTION 4: MAINTENANCE
Removing the Lower Housing
To remove the lower housing, push the locking tab on the
bottom of the bill acceptor and pull the lower housing to
the rear.
To Next Page
Loading...
