IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Value: Mains V
Mains voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vm VT ratio.
Value: Bus V
Bus voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the displayed
voltage is adjusted by the setpoint Vb VT ratio.
Value: Mains V L1-L2
Mains voltage phase L1 to L2.
Value: Bus V L1-L2
Bus voltage phase L1 to L2.
Value: Mains V L2-L3
Mains voltage phase L2 to L3.
Value: Bus V L2-L3
Bus voltage phase L2 to L3.
To Next Page
Loading...
