ComAp IG-NT - Setpoints - AMF Settings; Setpoints - Analog Protect; Setpoints - Basic Settings; Setpoints - Comms Settings

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
78
Setpoints - AMF Settings
1. EmergStart Del
2. MCB close del
3. MCB opens on
4. ReturnWithIntr
5. BreakerOverlap
6. RetFromIsland
7. ReturnTo mains
8. FwRet break
9. Mains ret del
Setpoints - Analog protect
1. Batt >V
2. Batt <V>
3. Batt volt del
Setpoints - Basic Settings
1. Nomin Power
2. Nomin current
3. CT ratio prim
4. CT ratio sec
5. Im3/ErFlCurCTp
6. Im3/ErFlCurCTs
7. VT ratio
8. Vg InpRangeSel
9. Vm VT ratio
10. Vm InpRangeSel
11. GenNomV
12. GenNomVph-ph
13. MainsNomV
14. MainsNomVph-ph
15. FixVoltProtSel
16. Nominal Freq
17. Nom frq offset
18. Gear Teeth
19. Nominal RPM
20. ControllerMode
21. FltRes GoToMAN
22. Local buttons
23. DispBaklightTO
24. DispBklStrtOff
25. FastHistPeriod
26. ConvCoefPulse1
27. ConvCoefPulse2 (for IS-NT only)
28. ConvCoefPulse3 (for IS-NT only)
29. ConvCoefPulse4 (for IS-NT only)
Setpoints - Comms settings
1. Gen-set name
2. Contr. address
3. RS232(1) mode
4. RS232(2) mode