ComAp IG-NT - Active Calls and SMS Notifications; Notification Configuration by Protection Type

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
83
Setpoints - Process Control single
1. Base load
2. Base PF
3. Import load
4. Import PF
5. Load ctrl PtM
6. PF ctrl PtM
7. I/E-Pm meas
8. I/E-Qm meas
9. PeakLevelStart
10. PeakLevelStop
11. PeakAutS/S del
12. Peak kVA Start
13. Peak kVA Stop
14. PeakKVAS/S del
15. Export limit
16. Derating1 strt (IS-NT only)
17. Derating2 strt (IS-NT only)
18. Derating1 end (IS-NT only)
19. Derating2 end (IS-NT only)
20. Derated1 pwr (IS-NT only)
21. Derated2 pwr (IS-NT only)
22. TempByPwr Treq (IS-NT only)
23. TempByPwr gain (IS-NT only)
24. TempByPwr int (IS-NT only)
25. Overheat prot (IS-NT only)
26. Island enable
27. ParallelEnable
28. Synchro enable
29. MFStart enable
30. #Neutral cont.
31. Watched contr
Setpoints - Process Control Multi
1. #SysBaseLoad
2. LocalBaseload
3. #SysPwrFactor
4. #SysLdCtrl PtM
5. #SysPFCtrl PtM
6. SysBaseLdMode
7. SysBasePFMode
8. Derating1 strt(IS-NT only)
9. Derating2 strt(IS-NT only)
10. Derating1 end(IS-NT only)
11. Derating2 end(IS-NT only)
12. Derated1 pwr(IS-NT only)
13. Derated2 pwr(IS-NT only)
14. Synchro enable
15. #Neutral cont
16. Watched contr
Setpoints - Sync/load Ctrl
1. SpeedRegChar
2. Voltage window