ComAp IG-NT Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
27
Engine warming
Engine params: Warming load
Warming temp
Max warm time
Reduces
requested load
Warming
Warming temp
Analog input
Service time alarm
Engine protect: Service time 1
Service time 2
Service time 3
Service time 4
WrnServiceT3+4
WrnServiceT1+2
Engine starting procedures
Engine params: Starting RPM
Prestart time
MaxCrank time
CrnkFail pause
Crank attempts
Idle time
Fuel solenoid
Starting
Stop solenoid
Starter
Prestart
Cranking
Crank procedure
Idle/Nominal
Idle run
Ignition
Operational
Engine starting procedure if Engine params: Fuel solenoid = DIESEL ENGINE with different setting of
FuelSol offset.
-5s
BO: Fuel solenoid
RPM
BO: Starter
Negative values possible only
with DIESEL setting.
BO: Fuel solenoid
BO: Fuel solenoid
0 s offset means that Fuel
solenoid is activated together
with Starter.
FuelSol offset
+5s
RPM > Starting RPM or
Oil pressure > Starting POil or
RunIndication1,2,3 = 1
Engine starting procedure if Engine params: Fuel solenoid = GAS ENGINE

ComAp IG-NT Specifications

General

Brand	ComAp
Model	IG-NT
Category	Controller
Language	English