IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
NOTE:
There isn't any relation between the default names of the force value function
blocks, associated binary inputs and the default names of the reserved setpoints.
In other words, the setpoint with default name Force value 3 is not related to the
Force value 3 function block.
This is one of the 16 setpoints reserved for using as alternative setpoints for the
force value functions. The alternative setpoint is to be assigned to a particular
force value function and renamed in GenConfig.
See also the input Force value 1.
NOTE:
It is not obligatory to use one of these reserved setpoints for a force value
function. It is possible to use also any other setpoint or value with matching
dimension and decimal resolution.
NOTE:
There isn't any relation between the default names of the force value function
blocks, associated binary inputs and the default names of the reserved setpoints.
In other words, the setpoint with default name Force value 3 is not related to the
Force value 3 function block.
This setpoint adjusts the reset (initial) value of the ExtValue 1. This initial value is
applied either when the controller is powered-on or when the ExtValue 1 is reset
by the binary input ExtValue1reset.
To Next Page
Loading...
Need help?
General
