IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
Binary input: ExtValue1reset
The ExtValue 1 is reset to it's default value when this input is activated and held
there until the input is deactivated. The default value is given by the setpoint
ExtValue1deflt.
While the reset input is active:
• The value does not respond to up and down inputs.
• The value does not accept new data that are written remotely from a
remote terminal using the ExtValue command.
NOTE:
Configuring of the reset input does not block writing the ExtValue remotely, in
comparison to the up and down inputs, which does. However, if the reset input is
active, the remotely written data are not accepted.
Binary input: ExtValue2reset
The ExtValue 2 is reset to it's default value when this input is activated and held
there until the input is deactivated. The default value is given by the setpoint
ExtValue2deflt.
While the reset input is active:
• The value does not respond to up and down inputs.
• The value does not accept new data that are written remotely from a
remote terminal using the ExtValue command.
NOTE:
Configuring of the reset input does not block writing the ExtValue remotely, in
comparison to the up and down inputs, which does. However, if the reset input is
active, the remotely written data are not accepted.
Binary input: ExtValue3reset
The ExtValue 3 is reset to it's default value when this input is activated and held
there until the input is deactivated. The default value is given by the setpoint
ExtValue3deflt.
While the reset input is active:
• The value does not respond to up and down inputs.
• The value does not accept new data that are written remotely from a
remote terminal using the ExtValue command.
NOTE:
To Next Page
Loading...
Need help?
General
