ComAp IG-NTC GC User Manual

IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
136
Setpoint: ExtValue3 rate
Group
Force value
Range [units]
1 .. 10000 [X/s]
Related FW
3.0
Force value
possible
YES
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 3 is beeing
changed while the input ExtValue3 up or ExtValue3 down is active.
Setpoint: ExtValue4deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
3.0
Force value
possible
YES
Force value
possible
YES
Description
This setpoint adjusts the reset (initial) value of the ExtValue 4. This initial value is
applied either when the controller is powered-on or when the ExtValue 4 is reset
by the binary input ExtValue4reset.
Setpoint: ExtValue4LoLim
Group
Force value
Range [units]
-32000 .. ExtValue4HiLim [X]
Related FW
3.0
Description
This setpoint adjusts the low limit of the value of ExtValue 4 if the value is
lowered/raised by the binary inputs ExtValue4 up and ExtValue4 down. The
ExtValue 4 is never lowered below this limit.
NOTE:
This limit is not taken into account if the value ExtValue 4 is written remotely from
a terminal using the appropriate command ExtValue #n.
NOTE:
For IS-NT only.

ComAp IG-NTC GC Specifications

General

Brand	ComAp
Model	IG-NTC GC
Category	Controller
Language	English