Communication Guide, ©ComAp – March 2014 122
IGS-NT Communication Guide 03-2014.pdf
Each user has his identification number (0 – 7). User with identification number 0 has an exceptional
position. This user has access to all groups of protected objects (this access cannot be changed
anyhow) and can define groups of access attributes to other users (1 – 7), reset their password and
set their name (alias of an identification number). Entering of password must be foregone by writing of
a user identification number.
Commands for IGS-NT
First it is necessary to enter an appropriate user and his password first to enable commands, if these
are protected by level 1-7
Argument has not been
written
Argument has not been
written
Close/open generator circuit breaker (IGS-
NT)
Clutch ON/OFF (ID)
Argument has not been
written
Close generator circuit breaker
Argument has not been
written
Open generator circuit breaker
Argument has not been
written
Close/open mains circuit breaker
Argument has not been
written
Close mains circuit breaker
Argument has not been
written
Open mains circuit breaker
Argument has not been
written
Reset from Init state (#1)
Set counter of engine starts
Set counter of unsuccessful engine starts
Set binary output RemoteSwitch1-8
(RemoteControl1-8 )
Reset binary output RemoteSwitch1-8
(RemoteControl1-8 )
Set pulse counters (IS-NT only)
To Next Page
Loading...
Need help?
General
