Communication Guide, ©ComAp – March 2014 123
IGS-NT Communication Guide 03-2014.pdf
Upper part
of a new
value;
YYYY –
Lower part
of a new
value)
0002YYYY
(YYYY -
new value)
(*) in HEX
# 8
If the controller setpoints are not valid after it is switched on, the controller goes to a blocked state. In
this state it is necessary to modify the setpoints from the controller keypad and switch off and on the
controller or from the external terminal and unblock the controller by Reset from Init state command.
Another condition necessary to unblock the application function of the controller is valid configuration.
# 2
Check if the setpoints ExtValueXLoLim and ExtValueXHiLim allow set the requested value to
ExtValue.
Commands for IM-NT
First it is necessary to enter an appropriate user and his password first to enable commands, if these
are protected by level 1-7
Argument has not been
written
Argument has not been
written
Argument has not been
written
Argument has not been
written
Argument has not been
written
Argument has not been
written
Argument has not been
written
Argument has not been
written
Reset from Init state (#1)
Set binary output RemoteSwitch1-8
(RemoteControl1-8 )
To Next Page
Loading...
Need help?
General
