InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
Ad B) Connection of IB-Lite to Ethernet/Internet by using of dynamic IP and AirGate
NOTE:
Use this possibility when you have not assigned static Ethernet IP address from your IT department or
static public IP from your internet provider.
1. Turn on the controller.
2. Setup“CommsSettings”directlyonthecontroller:
- Press button.Choose“CommsSettings”byusingofarrows and
press .
- Setup“IBLiteDHCP”and“AirGate”as ENABLED.
- Setup.“AirGateIP”as“airgate.comap.cz”.
NOTE:
“CommsSettings”ofcontrollercanbeaswellchangedbyusingofLiteEditsoftware
via
IL-NT RS232, IL-NT RS232-485 or IL-NT S-USB communication modules.
WARNING:
Disconnect power source from the controller before exchanging the communication
module!
3. Connect the IB-Lite to the router (or Internet/Ethernet socket) via UTP cable.
- Wait a while (or turn the controller off and on).
- Checkthe“AirGateID”:Pressfewtimes button on the basic controller display
until you see GSM/Modem status screen. Remember the AirGate ID.
CONTROLLER DISPLAY – GSM/MODEM STATUS SCREEN
TABLE OF AIRGATE DIAGNOSTIC CODES
4. For connection with controller use LiteEdit or InteliMonitor software or just a web browser with
your WebSupervisor account (http://websupervisor.comap.cz). Connect to the controller via
AirGate, type in the AirGate ID and use “airgate.comap.cz”asanAirGateaddress(AirGate
Server).