ComAp InteliPro - Page 56

InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
3-15
LITEEDIT: AIRGATE CONNECTION WEBSUPERVISOR: AIRGATE CONNECTION
Ad C) Connection of IB-Lite to Ethernet by using of static IP or to Internet by using of public static IP
NOTE:
Use this possibility when your IT department has a Static Ethernet IP at your disposal or when the
Static Public IP from your internet provider is available.
1. Turn on the controller.
2. Setup“CommsSettings”directlyonthecontroller:
- Press button.Choose“CommsSettings”byusingofarrows and
press .
- Setupitemsof“IBLiteIPAddr”,“IBLiteNetMask”and“IBLiteGateIP”accordingto
information from your IT department (internal network) or internet provider (public
network). “IBLiteDHCP”and“AirGate”hastobeDISABLED.
NOTE:
“CommsSettings”ofcontroller can be as well changed by using LiteEdit software via
IL-NT RS232, IL-NT RS232-485 or IL-NT S-USB communication modules.
WARNING:
Disconnect power source from the controller before exchanging the communication
module!
3. Connect the IB-Lite to the router via UTP cable.
4. For connection with controller use LiteEdit or InteliMonitor software or just a web browser with
your WebSupervisor account (http://websupervisor.comap.cz) or simply embedded SCADA
WebServerwithputtingofpublicIPAddress(“IBLiteIPAddr”)intotheaddressbar.
For more detail about communication of ComAp products, see the IL-NT, IA-NT, IC-NT
Communication Guide as published on ComAp download centre.