IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
This output is closed while the application is currently running in SPI mode. See
the chapter Description of Combi application for information how to switch the
application mode.
Binary output: SPtM mode
This output is closed while the application is currently running in SPtM mode. See
the chapter Description of Combi application for information how to switch the
application mode.
Binary output: MINT mode
This output is closed while the application is currently running in MINT mode. See
the chapter Description of Combi application for information how to switch the
application mode.
Binary output: Vgen <>
The output is closed while the generator over/under voltage alarm is present in the
alarm list.
Binary output: Vmains <>
The output is closed while the mains over/under voltage alarm is present in the
alarm list.
Binary output: Overcurrent
The output is closed while there is either the Generator IDMT Overcurrent or
Generator Short current alarms present in the alarm list.
Binary output: VectorShiftTrp
The output closes if the Vector shift protection gets active and the controller trips
the selected breaker. The output stays closed for 3s, then opens again.
NOTE:
See also the output VectorShiftAct.
Binary output: VectorShiftAct
The output closes if the Vector shift protection gets active. It stays closed for 3s,
To Next Page
Loading...
Need help?
General
