SECTION 5: PROGRAMMING AND OPERATION
19 of 40
SECTION 5: PROGRAMMING AND OPERATION
5.1 Stand Alone Unit
The control has three basic levels of operation /
programming.
By default if a control is not connected to a network,
then it assumes stand alone status.
1. Open level where access is open to anyone at
all times. see Page 20, Section 5.3.2.
2. Manager level, where settings may be changed
for normal operation, accessed through the
manager code, which may be changed to one
that can be remembered by the user. See Page
25, Section 5.5.
3. Engineer level where system settings may be
changed and accessed via engineer code,
which is not changeable. See Page 31, Section
5.6.
The following sections break down tasks available
and detail steps to be taken in each level.
SEQUENCE FOR SETTINGS
Set the functions in the order:
1. Set Configuration; Page 33, Section 5.6.3.
2. Calibrate temperature sensor; Page 36, Sec-
tion 5.6.5.
3. Set optimisation; Page 32, Section 5.6.2.
The remainder of the settings may be undertaken in
any order.
5.2 Network Unit
For network units, all functions of Section 5.1 are
the same. The open level will allow similar functions
on all network controls from a base unit or from any
other network control, dependent on how the
individual units have been site configured. See Page
21, Section 5.4 for options.
Networked units will need to be configured for
network options. See Page 31, Section 5.6.1.
SEQUENCE FOR SETTINGS
1. Configure each control for the network. See
Page 31, Section 5.6.1.
2. Configure each controller for its use with the
engineers code. See Page 31, Section 5.6.
3. Set operational settings with the manager
code. See Page 25, Section 5.5.
Sequences 1 and 2 must be c
arried out at each
networked station and may be carried out together.
Sequence 3 may be carried out from any "full
control" station for all other stations where operating
times and temperatures may be copied from one
control to another.
5.3 System Language
The Combat HVAC NRG Control has been
programmed to display in 5 languages.
To select or change the language See Page 19,
Section 5.3.1.
5.3.1 Set System Language
To Next Page
Loading...