Combat HVAC NRG Control - Table of Contents

© 2015 Combat HVAC
Limited
All rights reserved. No part of this work covered by the copyrights herein may be reproduced
or copied in any form or by any means - graphic, electronic, or mechanical, including
photocopying, recording, taping or information storage and retrieval systems - without the
written permission of Combat HVAC Limited.
Printed in U.K.
TABLE OF CONTENTS
SECTION 1: Introduction........................................................ 2
1.1 Safety Labels and Their Placement .............................2
1.2 What is an
NRG Control?.............................................2
1.3 General Requirements .................................................2
1.4 Control Location ........................................................... 2
1. 5 N e t work Installation...................................................... 2
1.6 Installation Requirements............................................. 3
1.7 Programming Details ....................................................3
SECTION 2: Specifications .................................................... 4
2.1 Material ........................................................................4
2.2 Keypad Layout ............................................................. 4
SECTION 3: Installation..........................................................6
3.1 National Standards and Applicable Codes ..................6
3.2 Installing the NRG Control ...........................................6
3.3 Electrical Installation Requirements.............................7
SECTION 4: Wiring..................................................................9
4.1 Network Wiring ............................................................9
4.2 Low Voltage Wiring .................................................... 10
4.3 CTU Wiring (Pektron Ignition Controller).................... 11
4.4 CTCU Wiring (Pektron Ignition Controller) ................. 11
4.5 CTU Wiring (Pactrol Ignition Controller)..................... 12
4.6 CTCU Wiring (Pactrol Ignition Controller) .................. 12
4.7 Interface Relay Wiring for Multiple Models
CTU 70 - 115.............................................................. 13
4.8 Interface Relay Wiring for Multiple Models
CTCU 11 - 32 & CTU 40 - 60 ..................................... 14
4.9 MGB/MOB Range Wiring - 1 Ø Cabinet Heaters....... 15
4.10 MGB/MOB Range Wiring - 3 Ø Cabinet Heaters ..... 16
4.11 Cabinet Heater Remote Lockout Reset Wiring
(With THERMOWATT Ignition Control) .................... 16
4.12 Cabinet Heater Remote Lockout Reset Wiring......... 17
4.13 Unitary Radiant System Wiring ................................ 17
4.14 CORAYVAC
®
and Multiburner Systems Wiring ........ 18
SECTION 5: Programming and Operation .......................... 19
5.1 Stand Alone Unit........................................................ 19
5.2 Network Unit .............................................................. 19
5.3 System Language ...................................................... 19
5.4 Network Open Level User Functions ......................... 21
5.5 Manager Settings.......................................................25
5.6 Engineer Settings ......................................................31
SECTION 6: Standard Screen Messages ............................ 39
6.1 Stand Alone Control Screen Messages .....................39
6.2 Network Control Screen Message ............................. 40
6.3 Fault Messages ......................................................... 40