Loading System MkII General
3
General
The Loading System MkII has been designed to enable the loading and
unloading of equipment from a flatbed truck or trailer in a safe manner.
The Loading System MkII incorporates a SkyReach Anchor unit which is
connected by a Self-Retracting Cable Lifeline to the full body safety harness
worn by the operative.
The SkyReach Anchor is designed to deform, absorb the energy and reduce
the resulting forces, when a fall occurs.
When working at lower heights, the system can be equipped with the Top
Column 4.7. In this configuration the anchor point is located 4,7 m above
ground level. When working at higher positions the system can be equipped
with the SkyReach Adaptor 5.9 which locates the anchor point 5,9 m above
ground level. The combination of Loading System MkII and SkyReach
Anchor, is tested to prove compliance to EN 795:2012 Type E, and is CE-
certified by DEKRA EXAM GmbH, Dinnendahlstraße 9, 44809 Bochum,
Germany, with identification no 0158.
The Loading System MkII can be used on a construction site or in a loading
yard and it can be moved to alternative locations as needed. To ease
transportation and storage, the Loading System MkII is designed to be flat
packed and stackable. When flat packed the total height of the base is 0,6 m.
The SkyReach Anchor itself can be separated and folded for ease of transport
between locations.
When used for unloading a trailer up to 8 m in length, the Loading System
MkII Single Unit can be used. If unloading a trailer between 8 and 14 m in
length, the Loading System MkII Double Unit should be used.
Read carefully through this user instruction before use of the product. In case
of questions and for clarification, please contact Combisafe for support.
To Next Page
Loading...