Safety Instructions Loading System MkII
8
Periodic inspection/inspection after a fall
To ensure the function and safety of the system, a safety inspection of the
Loading System Base, the SkyReach Anchor and the PFPE, needs to be
done by a competent person at least once every 12 months. The inspections
must be documented in a component record.
If an accident has occurred, e.g. a person falls, the items must be immediately
withdrawn from use and inspected by a competent person according to the
manufacturer´s safety check.
Please contact Combisafe for more information regarding inspections and
associated documentation.
The SkyReach Anchor is designed to deform when a fall occurs, to
absorb the energy and to reduce the resulting forces. When tested,
the maximum vertical deflection of the anchor point is 0,7 m.
Remember
• Plan fall prevention at an early stage, this will benefit everyone.
• Use only safety-checked products.
• Restrict access below and around installation and working area to prevent
injury to others from any fall hazard.
• Use tools designed for the type of work to be carried out.
• Keep the installation area in order.
• A safe workplace is a good workplace.
• Many fall accidents occur from a low height.
• Parts might be slippery when wet, be cautious when handling.
To Next Page
Loading...