Loading System MkII Recommended operation method
39
Recommended operating method
Single Unit usage
For unloading a flatbed with a length of up to 8 m, which will fit into the loading
zone as described in Figure 34, a Single Unit is required. The Single Unit
consists of one Loading System MkII Base with one SkyReach Anchor, one
6,2 m Falcon Fall Arrest Block, one full body harness, Top Column 4.7 (Art.
8805) or SkyReach Adaptor 5.9 (Art. 8806), please see Figure 3 in the
beginning of this document.
This method is based on a width of the flatbed loading area greater or equal
to 2,4 m. For any width less than mentioned, please contact Combisafe for
advice.
The Base must be positioned centrally to the zone, as shown below.
Figure 34. Working area illustration for a Single Unit usage.
1. Loading Zone
2. Operative
Any operative unloading a flatbed trailer should be wearing:
• appropriate footwear,
• reflective vest and helmet with chin strap,
• full body harness,
• harness extender 0.3 m for dorsal anchorage.
To Next Page
Loading...